Biamp RP-S4 Manual do Utilizador descarregar pdf (Página 4)

Back-Box Installation

Remove the back-box from the front panel (controls). Route cables through a

‘knock-out’ hole on the rear of the back-box. Install the back-box in a wall or

panel, in the same orientation as any standard single-gang electrical box.

The mounting surface may be from 1/8” to 1” thick

(3.175mm to 25.4mm)

The mounting cavity must be exactly 3.6” high,

2.25” wide, and at least 2.75” deep

(91.44mm H x 57.15mm W x 69.85mm D)

Insert the back-box into the wall or panel, then tighten the flange screws until

the flanges hold the box securely in place. Wire the remote panel pre-wired

pigtails to the appropriate cable conductors. Soldered connections with heat-

shrink insulation, or properly sized wire nuts, are recommended. Mount the

front panel to the back-box, being careful not to pinch or short the wires.

NOTE: When an RP-S4 is used with an RIK Remote Interface Kit, the RIK

circuit board will not fit inside the standard single-gang electrical back-box.

Therefore, the RIK must be installed external to the back-box (

et close enoug

to be connected using the wire harnesses provided). An alternative is to utilize

a double-wide electrical back-box, which has the additional space for an RIK.

Back-Box

flange

knock-outs

RP-L1 & RP-L2 Block Diagram

25k

linear

GND C +10V

green

red

white

low (ccw)

wiper

high (cw)

cwccw

RP-S4 Block Diagram

DPDT

green

red

white

down (depressed)

wiper

up (released)

wiper

down

white

red

green

585.9131.90A19Mar07

1 2 3 4 5

Comentários a estes Manuais

Sem comentários

Biamp RP-S4 Manual do Utilizador Página 4

Comentários a estes Manuais